产品

Browse pallet and workpiece-carrier conveyor chains by mechanical architecture. Begin with how the carrier is supported, whether accumulation is required, and which roller or pin interface meets the guide rail or fixture. Then use the model pages for dimensional confirmation.

Product families for pallet conveyor systems

双节距侧滚子链

C216AL-PSR 双节距聚甲醛侧滚子链，节距 50.8 毫米，适用于托盘和工件输送机。确认…

空心销输送链

C216AHP 空心销输送链，节距 50.8 毫米，孔径、销轴、链板、拉伸强度和质量均经过精确验证……

塑料滚子双加链

BS30-C216A 3.0x 双滚轮托盘输送链，带塑料滚轮，50.8 毫米节距，尺寸经过精确验证……

聚甲醛侧滚子链

20A-PSR 型聚甲醛侧向滚子链，节距 31.75 毫米，适用于轨道支撑式托盘和工件输送机。尺寸精确……

不锈钢侧滚子链

06C-CDL 不锈钢侧滚子链，节距 9.525 毫米，尺寸数据经过验证，适用于输送机轨道、托盘等。

钢制滚子双加链

BS25-C208AR 双链钢辊，节距 25.4 毫米，适用于托盘和工件输送机。确认辊子……

Choose the family from the machine interface

双加链

For free-flow pallet conveying where roller geometry allows a carrier to travel faster than chain speed and to accumulate while the chain continues to move. Confirm roller type, rail, stop sequence and queue length.

侧滚子链

For layouts in which outboard rollers support or guide the chain on dedicated rails. Confirm side-roller position, diameter, rail section and carrier load path.

空心销输送链

For chains that accept cross rods, fixtures or project-specific hardware through the hollow pins. Review the base chain and fixture load path as separate design items.

Pallet Conveyor Chain Families

Use the parent family to compare roller arrangements, pitch series and system interfaces before opening individual model pages.

Replacement identification should start on the machine

Measure several pitches, photograph the chain from the side and end, record sprocket tooth count and bore, and show the rail or carrier surface that contacts the chain. Pitch alone does not establish interchangeability because roller position, pin dimensions, plate profile and strand spacing also affect fit.

For new conveyors, provide the loaded carrier mass, conveyor length and speed, accumulation sequence, rail concept, strand centers, drive/take-up layout and environment. Keep unknown values open for engineering confirmation rather than copying them from a visually similar model.

What to include with an RFQ

Project input	Useful information
Chain	Model if known, several-pitch measurement, roller/pin arrangement and quantity.
Carrier	Loaded mass, dimensions, underside contact and station locating method.
Conveyor	Length, speed, strand spacing, rail profile, transfers and accumulation zones.
驾驶	Sprocket tooth count, bore, drive position, shaft alignment and take-up.
环境	Temperature, contamination, moisture and lubrication constraints.