Producten

Browse pallet and workpiece-carrier conveyor chains by mechanical architecture. Begin with how the carrier is supported, whether accumulation is required, and which roller or pin interface meets the guide rail or fixture. Then use the model pages for dimensional confirmation.

Product families for pallet conveyor systems

Dubbele steek zijrolkettingen

C216AL-PSR dubbele steek polyacetaal zijrolketting met een steek van 50,8 mm voor pallet- en werkstuktransportbanden. Bevestigen…

Holle pinnen transportkettingen

C216AHP holle-pen transportketting met een steek van 50,8 mm en exact gecontroleerde boring, pen, plaat, treksterkte en massa…

Kunststof rolkettingen met dubbele plus

BS30-C216A 3.0x dubbele plus pallettransportketting met kunststof rollen, 50,8 mm steek en een exact gecontroleerde afmeting…

Polyacetaal zijrolkettingen

20A-PSR polyacetaal zijrollenketting met een steek van 31,75 mm voor railondersteunde pallet- en werkstuktransportbanden. Exacte afmetingen…

Roestvrijstalen zijrolkettingen

06C-CDL roestvrijstalen zijrollenketting met een steek van 9,525 mm en geverifieerde maatgegevens voor transportbandrails, pallets, enz.

Dubbele plus stalen rolkettingen

BS25-C208AR Dubbele Plus-kettingrollen van staal met een steek van 25,4 mm voor pallet- en werkstuktransportbanden. Bevestig de rol…

Choose the family from the machine interface

Dubbele Plus Kettingen

For free-flow pallet conveying where roller geometry allows a carrier to travel faster than chain speed and to accumulate while the chain continues to move. Confirm roller type, rail, stop sequence and queue length.

Zijrolkettingen

For layouts in which outboard rollers support or guide the chain on dedicated rails. Confirm side-roller position, diameter, rail section and carrier load path.

Holle pinnen transportkettingen

For chains that accept cross rods, fixtures or project-specific hardware through the hollow pins. Review the base chain and fixture load path as separate design items.

Pallet Conveyor Chain Families

Use the parent family to compare roller arrangements, pitch series and system interfaces before opening individual model pages.

Replacement identification should start on the machine

Measure several pitches, photograph the chain from the side and end, record sprocket tooth count and bore, and show the rail or carrier surface that contacts the chain. Pitch alone does not establish interchangeability because roller position, pin dimensions, plate profile and strand spacing also affect fit.

For new conveyors, provide the loaded carrier mass, conveyor length and speed, accumulation sequence, rail concept, strand centers, drive/take-up layout and environment. Keep unknown values open for engineering confirmation rather than copying them from a visually similar model.

What to include with an RFQ

Project input	Useful information
Chain	Model if known, several-pitch measurement, roller/pin arrangement and quantity.
Carrier	Loaded mass, dimensions, underside contact and station locating method.
Conveyor	Length, speed, strand spacing, rail profile, transfers and accumulation zones.
Drive	Sprocket tooth count, bore, drive position, shaft alignment and take-up.
Environment	Temperature, contamination, moisture and lubrication constraints.